Kt 70 Installation Manual //free\\

Dispose of the KT 70 and its components per local electronic waste regulations.

Turn on the avionics master. Verify that the KT 70 powers up, displays its self-test sequence, and does not trip the circuit breaker. Check that the display dimming responds correctly to the aircraft panel lighting bus. Kt 70 Installation Manual

Verify that the unit powers up, the display illuminates, and the "SBY" (Standby) mode is shown. Dispose of the KT 70 and its components

For cable runs between 10 and 20 feet, use low-loss foam coaxial cables like or Beldon 9913 . Check that the display dimming responds correctly to

2.2 Amps maximum at 14V; 1.1 Amps maximum at 28V.

Once mechanical and electrical installations are complete, slide the KT 70 into the mounting sleeve. Tighten the front-panel jackscrew to seat the rear connectors securely. Mode S Address Configuration