Videojet 1280 Manual Pdf Install -
If the PDF feels overwhelming (the manual is ~300 pages), remember that Videojet requires a to perform the initial commissioning for warranty validation. You can handle the physical mounting and air/fluid hookup, but the final configuration often requires a service code.
Ideally, mount the printhead at the same level as the cabinet. Avoid placing the printhead more than 2 meters above or 1 meter below the cabinet base.
Mount the encoder wheel so it rides directly on the conveyor belt or a driving shaft.
Mount the printer cabinet on a stable, level surface, a dedicated Videojet floor stand, or a secure wall bracket. Ensure the touchscreen is at an ergonomic height for machine operators. Printhead Positioning
The installation process can be broken down into a few logical phases:
The printer weighs approximately 39.5 lbs (17.9 kg) when dry and unpacked. videojet 1280 manual pdf install
The Videojet 1280 continuous inkjet (CIJ) printer is a reliable, modular solution designed to make industrial coding accessible and affordable. Proper installation ensures peak uptime, crisp code quality, and minimal maintenance.
Mount the printhead at the appropriate distance from the product (typically 2-12mm) to ensure high-quality, clear codes.
Videojet 1280 printer cabinet (housing the SIMPLICIty™ touchscreen interface) Printhead assembly with attached umbilical cable Mounting brackets or optional floor stand Power cable Starter fluid cartridges (Ink and Make-up/solvent) Basic operator manual
The official is your best friend during installation. Here is everything you need to know about finding the right document and the key steps for setting up this industrial printer.
Before powering on, check that all connections and cables are properly connected and inspect for any damage. Initial Power On: power button on the back of the machine. If the PDF feels overwhelming (the manual is
Proper installation is critical to prevent premature ink system failures and to ensure accurate print quality. Site Preparation
: Ensure the umbilical (the cable connecting the cabinet to the printhead) has no sharp bends or kinks. The minimum bend radius is typically 150mm (6 inches). Fluid Setup
Perform a Nozzle Flush routine using the recommended wash fluid. Moisture or ink buildup on the deflection plates.
Are you integrating this with a ? What is the exact speed of your production line?
: Ensure all cables (power and data) are properly connected and that there is adequate clearance around the printer for maintenance. Avoid placing the printhead more than 2 meters
Mount the printhead face between 2 mm and 15 mm from the target substrate. A distance of 4 mm to 6 mm yields optimal sharpness. Angle of Attack: Position the printhead perpendicular ( 90∘90 raised to the composed with power
| Check | Pass/Fail | | :--- | :--- | | Ink and make-up bottles are correctly seated | ______ | | Printhead cable is fully seated (no kinks) | ______ | | Ground resistance <1 ohm from printer to earth | ______ | | Make-up bottle vents open (no vacuum lock) | ______ | | Emergency stop works (pneumatic shutoff, if fitted) | ______ | | Sample prints – 1,000 consecutive without error | ______ |
service module is correctly seated; it is designed for tool-free replacement in under 5 minutes. Quick Specifications 1280, 1240 Technical Training Guide - 01 - AA - Scribd
By following this guide and consulting the full manual, you can ensure the optimal installation and performance of your Videojet 1280 printer.