: Allows technicians to set the printer's destination region and update firmware.
: MG3500 series (including MG3550), MG3600 series (such as MG3640), and even some reports of success with IP7240.
However, always weigh the risk of malware against the cost of professional service. If you decide to proceed, follow the safety steps in this guide diligently. With the correct precautions and a clear understanding of the process, you may very well be on your way to printing again in just a few minutes.
The Canon Service Tool V.4718 is a specialized Windows-based software utility used by technicians to perform maintenance operations on Canon inkjet printers. Every time your printer cleans its printheads, excess ink is pumped into physical foam pads (absorbers) inside the machine. The printer estimates this ink volume using an internal counter.
: The tool resets the counter, but it does not empty the ink pads. If you continue using the printer without cleaning or replacing the pads, you risk an ink leak that could permanently damage your printer.
Turn off your Canon printer, but leave it plugged into the power source.
: The waste ink absorber is almost full (warning stage).
The Canon Service Tool V.4718 is an official service software application used by technicians to calibrate, configure, and reset Canon Pixma printers. While Canon does not officially distribute this software to consumers, it has become widely available online as a crucial utility for DIY printer maintenance.
The safest way to handle a hardware limit error is to contact Canon support or visit an authorized service provider. They have access to the genuine, updated Service Tool and can physically replace the saturated ink pads, ensuring your printer does not leak ink later. Use Built-In Maintenance Features
The printer will initialize, move the print carriage, and print a single sheet containing a counter value confirmation (e.g., D=000.0 ).
To install and use Canon Service Tool V.4718, follow these steps:
If you open the tool and see "Error 006," it means your printer was not properly booted into Service Mode, or the software version does not support your specific printer firmware. Supported Canon Printer Models
