Airbot Hypersonic Pro Manual [updated] Page

without the dust cup and filters properly installed in place.

: Attach the wind pipe to the main handle motor until it clicks, then connect your desired attachment (e.g., the fluffy roller floor brush) to the other end.

This may indicate the brush roller is stuck or the battery is empty. Check the motorized head for hair tangles.

When you unbox your new Airbot, you'll find a complete set of tools ready to help you clean. Here's a list of the standard items that should be included:

A: Absolutely not. This is a dry vacuum only. Sucking up water will short-circuit the motorized head and destroy the HEPA filter.

For any further assistance regarding your Airbot Hypersonic Pro, refer to the printed manual or contact customer support.

The dustbin is overfilled past the "MAX" line. Solution: Empty the dustbin immediately.

This is the vacuum's default mode and where its "smart" power really shines. The infrared dust sensor constantly monitors the airflow, detecting fine dust, hair, and other particles in real-time. The vacuum instantly and to best suit the situation.

| Problem | Likely Cause | Solution (per manual) | | :--- | :--- | :--- | | | Low battery or thermal cutoff | Charge for 4-5 hours. Cool down for 30 min. | | Suction feels weak | Full dust cup or clogged filter | Empty cup & wash HEPA filter. | | Brush roll not spinning | Tangled hair or carpet too thick | Use the built-in groove cutter to remove hair. | | Battery flashing red | Overheating or deep discharge | Move to cool area; recharge. |

Wash both the HEPA filter and the cyclone mesh thoroughly under cold running water. Do not use detergents.

However, it earns a due to the sparse documentation. If you are an intermediate to advanced pilot who knows how to resource map a Betaflight target and solder without step-by-step pictures, this is one of the best F7 boards on the market.

Align the with the air intake nozzle of the Main Body . Push it in firmly until you hear a distinct "click" sound.