Motorola Dr3000 Programming Software _top_ -

Enter your licensed Tx and Rx frequencies. Ensure you set the correct Color Code (usually CC1 by default) to prevent interference from other local systems.

Managing the repeater's internal software. motorola dr3000 programming software

Follow this sequence to read from and write to your Motorola DR3000 repeater safely. Step 1: Physical Connection Turn off the DR3000 repeater. Connect the programming cable to the computer USB port. Attach the other end to the repeater accessory port. Enter your licensed Tx and Rx frequencies

To avoid frustration, ensure your PC meets these minimum requirements: Follow this sequence to read from and write

is going to be part of a larger network—such as an IP Site Connect (IPSC) or Capacity Plus system—you must configure the repeater's networking parameters.

To begin programming, ensure you have the following hardware and software environment:

and connect your PC to the front USB port using the correct programming cable. Open the CPS application.