⚙️ The iPROG+ software includes built‑in scripts to automatically configure the I²C bus speed and addressing. No manual pin reassignment is required.
If you are interested, I can provide the pinout for the BDM adapter or the CAN-based odometer adjustment steps. iprog eeprom adapter pinout portable
Leave the WP (Pin 3) and HOLD (Pin 7) unconnected on the portable probe, but solder a 10k ohm resistor from iProg Pin 7 to VCC (Pin 8) inside the adapter. This keeps the EEPROM in "run" mode. ⚙️ The iPROG+ software includes built‑in scripts to
2. SPI Bus Configuration (e.g., 95040, 95160, 95320, 25Cxxx) Leave the WP (Pin 3) and HOLD (Pin
When making a portable cable for the iProg, you often need to bridge specific pins (like tying A0, A1, A2 to GND or VCC depending on the chip) directly in your custom harness so you don't have to set jumpers on the fly.
→ SOIC8 chip side
Open the corresponding script module (e.g., Odometer -> Airbag -> EEPROM -> 25xxx ).