Kes Geyser Load Control Timer Manual: New [better]

Has anyone else noticed the updates in the ? I just installed the latest unit and spent the afternoon decoding the instructions so you don't have to.

Ensures settings are not lost during power outages.

After a power outage or load shedding, the timer's lights are flashing in an unusual pattern, and the override button is disabled. Possible Solution:

This comprehensive manual provides complete instructions for installing, programming, and troubleshooting the newest model of the KES Geyser Load Control Timer. ⚠️ Safety Warnings and Precautions kes geyser load control timer manual new

Adjusts the hour setting for the clock and timers.

Turn the main power switch at the master distribution board. Turn OFF the geyser isolator switch. 2. Wiring for DB Mount

While holding , press H+ (Hour) to set the current hour. Has anyone else noticed the updates in the

For more technical details or to view the full diagram, you can refer to the official KES ISG1201 Guide on Scribd . Geyser Load Control Timer ISG1201 Guide | PDF - Scribd

While holding , press M+ to set the exact current minute. Release the 🕐 button. 2. Setting Daily ON/OFF Schedules

The timer cuts power to the geyser completely, ignoring all schedules. Use this mode when going on vacation. After a power outage or load shedding, the

Before handling any electrical wiring, read these critical safety instructions:

Optimized for solar setups. OFF from 08h00 to 15h00 and during all peak demand times. Prog 3 3 flashes / second

Ensure the main circuit breaker feeding the timer is turned ON. Let the unit charge for 15 to 30 minutes, then press the Reset pinhole button to clear the memory and reboot the CPU. 2. The Geyser Turns On at the Wrong Times

To switch between the four pre-programmed profiles: