Verified Updated | Evoko Liso Factory Reset

If you can still access the administration settings, this is the safest method.

Ensure the firmware files are in the root directory of the USB drive, not inside a subfolder.

The latest Evoko Liso firmware image file (downloaded from the official Evoko support portal). Step-by-Step Instructions

Enter your or use an authorized RFID card.

Enter the PIN (default is usually 0000 or the one set during deployment). evoko liso factory reset verified

will reboot into the initial configuration screen, requiring it to be re-claimed and re-connected to .

Ensure the network port assigns IP addresses automatically; otherwise, you must manually configure a static IP on the Liso screen during setup.

Find the small pinhole reset button on the device (usually located near the power/ethernet ports). Trigger the Flash:

Continue holding the reset button for roughly 5 to 10 seconds until you see the Evoko boot screen change or an installation progress bar appear. Release the button. If you can still access the administration settings,

Room name, language settings, and customized background images. PIN Codes: Administrator passwords.

If the device hangs on the "Connecting to Server" screen immediately after a factory reset, check the following network configurations:

How to Perform an Evoko Liso Factory Reset (Verified Methods)

Unplug the Power over Ethernet (PoE) cable or power adapter from the Evoko Liso to . Step-by-Step Instructions Enter your or use an authorized

Open your web browser and log into your Evoko Home management application using your admin credentials.

Confirm the prompt. The device will wipe its local cache, disconnect from the Evoko Home server, and reboot into the initial setup wizard. Method 3: Remote Reset via Evoko Home Server Panel

If you do not feel a distinct click when pushing the paperclip into the reset pinhole, the internal tactile button may be damaged. Power down the device, realign your tool straight into the hole, and press gently. The Device Re-downloads Old Settings After a Reset

The system will automatically begin the flashing process after 30 seconds. Do not remove power during this process.

A will appear. Allow it to finish to start the flash.