Biosystems Bts 350 User Manual Jun 2026

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Aspirate a mild laboratory detergent or deproteinizer solution into the system.

: Graphic backlit LCD screen paired with an ergonomic keypad. 2. Installation and Initial Setup

Ultimate Guide to the BioSystems BTS-350 User Manual The BioSystems BTS-350 is a semi-automated clinical chemistry analyzer used globally in medical laboratories. Operating this device efficiently requires a deep understanding of its technical mechanics, calibration needs, and routine maintenance protocols. biosystems bts 350 user manual

Prepare all blanks, calibrators, quality controls, and patient samples according to the specific BioSystems reagent kit instructions. Ensure all fluids are at room temperature unless otherwise specified. Step 3: Aspiration and Reading Select the desired technique from the main menu.

Allow the system to warm up for 10 to 15 minutes so the Peltier temperature control stabilizes at the target temperature (typically 37°C for enzyme assays). 3. Software Navigation and Programming

The general workflow for a typical test follows a consistent sequence guided by the software. This public link is valid for 7 days

Set the : Input aspiration volume (typically 400 µL or 500 µL) and delay/read times.

: Detailed diagrams for replacing the peristaltic pump tubing.

Measures the change in absorbance over time, ideal for enzymes. Can’t copy the link right now

Low energy consumption with optional 2-hour battery backup. 2. Installation and Technical Specifications Proper installation is crucial for accurate analysis. The is compact (420 x 350 x 216 mm) and lightweight (4 kg). Environmental Requirements Voltage: Temperature: Relative Humidity: Up to Altitude: Filters: 8 hard-coated, dust-free filters. Spectral Range: 340nm340 n m 670nm670 n m (includes space for optional wavelength). Photometric Range: Absorbance ( 3. Getting Started: User Interface and Operation

Clean the flow cell with detergent. Run an optical test. Contact service if the message persists. Air bubbles in the flow cell or unstable temperature.