Installation Manual: Commax Dp-ra01

Re-check the dedicated door release contact wiring connections on your setup. If you need help tailoring this setup, tell me: What are you connecting to? What is the estimated cable run distance between units? Are you connecting an electric door strike or lock ? Share public link

| Specification | Details | | :--- | :--- | | | DP-RA01M (Master), DP-RA01S (Slave) | | Power Source (Master) | AC 230V, 50-60Hz | | Power Source (Slave) | Supplied by Master via wiring | | Audio Output | 70mW across 8 ohm | | Call Sound Output | High 400mW / Low 100mW (across 8 ohm) | | Wire Type | 0.65mm diameter (Approx. 22 AWG) | | Wiring Distance (Room to Room) | 30 meters (Using 0.65mm wire) | | Wiring Distance (Unifon to Gate) | 50 meters (Using 0.65mm wire) | | Dimensions (WxHxD) | 88 x 230 x 70 mm | | Weight (Master) | 450g | | Weight (Slave) | 600g | | Compliance | CE (LVD: EN60065, EMC: EN61000) | commax dp-ra01 installation manual

: Secure the included wall-mounting bracket to a flat surface using the provided screws. Wiring Connections : Are you connecting an electric door strike or lock

Position the wall-mounting bracket at your preferred viewing height (typically 1.4 to 1.5 meters from the floor). Wiring Connections : Position the wall-mounting bracket at

Align the groove on the back of the DP-RA01 with the bracket and pull it down to secure it. :

Align the slots on the back of the DP-RA01 handset with the hooks on the wall bracket.

(Remember to follow manufacturer safety guidance and local codes during installation.)