Scale buildup from hard water is a primary cause of failure in water heaters, dishwashers, and washing machines. Soft water prevents this scale, extending the life of your appliances and reducing the frequency of expensive repairs.
Take a blunt tool, such as a broom handle, and gently push down on the salt crust. Break up the hardened layer carefully to allow the pellets to collapse into the water below. Do not strike the sides of the plastic tank. Water Level Too High (Flooded Tank)
This article is for informational purposes. Always consult your specific owner’s manual for model-specific error codes. Rheem and GE are trademarks of their respective owners. 40278 water softener full
Hard water leads to scale buildup inside pipes, which can reduce water flow and pressure. It dramatically shortens the lifespan of water-using appliances like water heaters, dishwashers, and washing machines. It makes soap less effective, leaving a film on your skin and hair, and creates stubborn, hard-to-clean spots on glassware, dishes, and fixtures. For many homeowners, the solution is a whole-house water softener.
When water enters the brine tank but cannot exit during the regeneration cycle, it causes a structural backup. The most common points of failure include: Scale buildup from hard water is a primary
Typically, the brine tank (the salt tank) should have a few inches of water at the bottom, topped with salt. If the water level is rising above the salt, or if the tank is near the brim, it indicates a failure in the brine draw phase of the regeneration cycle 1.2.1 . A properly functioning softener will: the tank with water to dissolve salt. Draw the brine out to regenerate resin. Rinse the system. If the "draw" step fails, the tank stays full. Top Reasons Your Brine Tank is Too Full
Uses approximately 15–18 gallons of water and as little as 2.5 lbs of salt per regeneration cycle, which takes about 20–26 minutes. Pros and Cons Troubleshooting Tips - WaterBoss Break up the hardened layer carefully to allow
: Connect the water supply line to the softener's inlet port and the outlet line to your home's cold water line. Pay close attention to the directional arrows on the control valve to ensure water flows through the system correctly.