Caraflo V200 Shower Instructions !free! ⚡

The display glowed green. A summary appeared:

| Parameter | Specification | | :--- | :--- | | | 10 bar | | Flow Pressure (Hot & Cold) | 0.5 - 5 bar | | Max Mixed Water Temperature | 46°C | | Recommended Max Shower Temp | 41°C | | Hot Supply Temperature | 55 - 65°C | | Cold Supply Temperature | ≤ 25°C |

The water cut off entirely. A turbine roar kicked on from the ceiling, blasting him with 80-mph heated air like he was standing behind a jet engine. His bath mat flew across the room. caraflo v200 shower instructions

Isolate the main hot and cold water supplies to the vehicle. Unscrew the valve nuts from the wall connectors. Remove the valve body from the wall.

The valve is typically factory-set to a maximum safety temperature of around 38°C . To increase the temperature beyond this limit, you must press the safety override button while turning the handle. The display glowed green

38°C (with safety override button)

Debris, solder flux, and pipe shavings can ruin the thermostatic cartridge. Flush both the hot and cold water supplies thoroughly before connecting the valve. 2. Check Supply Orientations His bath mat flew across the room

Leave the shower controls open and disconnected throughout the winter storage period. Troubleshooting Common Issues

“Temperature handle stiff” → Limescale inside – remove cartridge, clean, apply silicone grease.

Leave the shower mixer in the "open" position throughout the winter storage period. 4. Troubleshooting Common Issues Likely Cause Low Pressure Clogged showerhead or weak pump. Descale the head; check if the pump filter is clear. Dripping Outlet Worn ceramic cartridge or O-ring.

Take out the wire mesh filters located inside the hot and cold inlets.