Ys9082hp Mptool Repack Verified 🆓

The tool should auto-detect the NAND flash, but if not, you must select it.

Once the MPTool recognizes the drive (usually showing a "Ready" status in one of the numbered slots):

Risks and mitigations

Wait for the tool to test the NAND, flash the firmware, and partition the drive. The process may take 5–20 minutes. The box will turn green and say "Pass".

It is important to understand that using the MPtool will result in the complete, permanent, and unrecoverable loss of all data on the drive. The low-level format resets every bit on the NAND flash. There is no software that can retrieve files from an SSD after it has been subjected to a full MPtool flash. ys9082hp mptool repack

The YS9082HP is a SATA 6Gbps SSD controller produced by Yeestor (SiliconGo / 得一微电子). It is a 4-channel, 4-CE-per-channel design that delivers solid sequential read speeds of up to 550 MB/s and write speeds up to 510 MB/s, making it ideal for budget-friendly consumer SSDs.

: Community-maintained versions are frequently hosted on the Yeestor MPTools page at USBDev.ru.

Even with the repack, you may encounter issues. Here is the fix matrix:

A prompt will pop up asking to initialize the drive. Choose either or GPT . The tool should auto-detect the NAND flash, but

If your SSD is corrupted, your computer's operating system likely won't detect it normally. You must force the controller chip into its fundamental bootloader state, widely referred to as .

[DRAM] Speed=400 TCL=6 [Flash] ReadRetry=Enable ReadRetryTable=2

The original factory versions of these tools are often leaked from manufacturing plants. They are frequently messy, written in specific languages (often Chinese), and missing the necessary configuration files for different types of flash memory (NAND).

These tools are used to re-flash the firmware (FW_HPS2818B, for example) directly onto the YS9082HP controller, which can solve issues where the drive doesn't identify properly in Windows or is "bricked". The box will turn green and say "Pass"

Would you prefer to first, or find a different tool ? Share public link

Solid State Drives (SSDs) have become the backbone of modern computing, but like any storage medium, they can fail, corrupt their firmware, or enter a locked "ROM" state due to bad blocks or power interruptions. For tech enthusiasts, IT professionals, and data recovery specialists, discovering the right tools to revive a dead drive is critical.

Bundle various libraries so the tool recognizes more SSD brands.

: Allows for editing the configuration (often requires a blank password).

Select the correct firmware file (e.g., versions like FW_HPS2818B ) that matches your NAND flash type.

Find the two small pads labeled "ROM" on the SSD's circuit board. Use the tweezers to short these two points together. While maintaining the short, connect the SSD to your PC via the SATA-to-USB adapter.