Understanding the specific operational guidelines, maintenance cycles, and safety mechanisms outlined in the TOMY SX-700 Operator's Manual ensures that your lab achieves optimal sterilization while preserving the long-term reliability of the machine. 📊 TOMY SX-700 Technical Specifications Overview
Relieves pressure automatically if it exceeds the maximum safe level.
| Error Code | Meaning (Per Manual) | Fix (Per Manual) | | :--- | :--- | :--- | | | Temperature sensor failure (open circuit) | Call service. Do not use. | | E-12 | Water shortage during cycle | Check distilled water tank level. Prime the pump. | | E-21 | Door interlock failed | Door not latched fully. Clean magnetic sensors. | | E-26 | Cooling fan malfunction | Clean fan filter on back of unit. Restart. |
Look for signs of fraying or heat damage on the electrical connections. 5. Troubleshooting Common Error Codes autoclave tomy sx700 manual best
Do not attempt to open the lid until the chamber temperature drops below 80°C and the pressure gauge reads exactly zero (0 MPa). Wear heat-resistant autoclave gloves to remove the baskets. 4. Maintenance and Care Schedule
The chamber temperature exceeded 137°C. Turn off the power, check for a faulty sensor, or ensure the chamber is not heavily overloaded. Over-Pressure Fault
Follow the official for detailed monthly and annual inspections. Do not use
Open the lid and check the water level inside the chamber. The water must cover the heating element completely and reach the base plate level.
If you encounter an error, the display will show a code. Always consult your manual for specific resolutions:
The Tomy SX700 proved to be a valuable asset to the hospital, providing consistent and reliable sterilization results. Dr. Smith was impressed by the machine's performance and the manufacturer's attention to detail in creating a comprehensive manual. | | E-21 | Door interlock failed | Door not latched fully
emphasizes safety and proper installation to prevent injury or equipment damage. Oslo University Hospital Research Operating Modes
Adjust the sterilization temperature and time using the up/down arrows based on your protocol (Standard cycle: 121°C for 20 minutes). Step 4: Running the Cycle Press the button.
Daily:
This comprehensive guide synthesizes the essential protocols, safety measures, and troubleshooting steps found in the official Tomy SX-700 instruction manual. 1. Technical Specifications and Overview