Oscam+server+config [2021] <2027>

[webif] httpport = 8888 httpuser = admin httppwd = strongpassword httprefresh = 10 httpallowed = 192.168.0.0-192.168.255.255

[reader] label = local_smartcard protocol = smartreader device = 001:002 caid = 098C boxid = 12345678 detect = cd mhz = 357 cardmhz = 357 group = 1 emmcache = 1,3,2,0 Use code with caution.

Will your clients connect via ?

: Defines the "Readers" (sources). This is where you configure local smartcard readers or connect to external peer servers. oscam+server+config

: Allows the local receiver to use the OSCam server. 2. oscam.server (The Card/Peer Config)

[reader] label = local_card protocol = internal device = /dev/sci0 detect = cd mhz = 450 cardmhz = 2700 group = 1 emmcache = 1,3,2 Use code with caution. Example 2: Remote CCCam Server

oscam.user defines which client accounts are allowed to connect to the server. Each [account] section specifies a username, password, allowed groups, and other permissions. [webif] httpport = 8888 httpuser = admin httppwd

: The card reader configuration file defining your local hardware readers or remote proxy feeds.

: The output layer. It defines local accounts, passwords, permissions, and group access for your client boxes.

directory (for Enigma-based systems) or similar paths on Linux and Raspberry Pi. www.linuxsat-support.com oscam.conf (Main Configuration) This is where you configure local smartcard readers

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

If you are running a local smartcard via an external USB serial reader, your configuration will target a local system block device: