Manual-adast-maxima-mh-80-2

Features a motorized backgauge for positioning material, often with a display (LED on later versions) to show measurements.

Apply a thin layer of medium-grade machine oil to the main guideways and slide tracks.

This label most likely names a revision-2 user/maintenance manual for an Adast Maxima MH-80 product. Treat it as the primary source for installation, operation, and service of that specific model and confirm details by opening the manual’s front pages or contacting the manufacturer. Manual-adast-maxima-mh-80-2

: Inspect the hydraulic oil for oxidation or milkiness, which points to water contamination. Drain, flush, and refill the system with fresh anti-wear hydraulic oil.

: Approximately 700 kg (approx. 1,540 lbs), making it a significant piece of industrial equipment requiring specialized moving equipment. Treat it as the primary source for installation,

Two-Hand Start: The operator must press two buttons simultaneously to engage the knife, ensuring hands are clear of the cutting zone.Infrared Light Barriers: Electronic sensors detect any intrusion into the cutting area and immediately halt the blade.Shear Bolt Protection: A mechanical safety pin that breaks if the knife hits an obstruction, preventing damage to the main motor.Emergency Stop: Large, red mushroom buttons located prominently on the machine for instant power cutoff. Installation and Setup

The hydraulic clamp pressure can be adjusted based on the material, allowing for the processing of sensitive materials without marking, as well as high-pressure cutting for dense paper stacks. : Approximately 700 kg (approx

While Adast's official documentation from the era would specify exact grades, experienced technicians generally recommend a high-quality hydraulic oil with anti-wear properties, typically ISO VG 32 or VG 46, depending on the ambient temperature of the operating environment. A standard hydraulic oil like Mobil DTE 24 or its equivalent is often a safe starting point for many hydraulic guillotines of this class. The user was also wise to question, "Do you suggest to replace the oil from the tank completely or just add to it? Is there a possibility to find some short of 'incompatibility' between the new and the old oil?" This is an excellent point. When the oil type is unknown, it is always best practice to drain and replace the entire reservoir with fresh oil of a known specification to prevent a chemical reaction between incompatible additive packages.

The Adast Maxima MH-80 is an ideal machine for: