V2000-c | Rfid Access Control User Manual Repack

Before mounting, ensure the power is disconnected. The rear of the unit features a color-coded wiring harness. Description Positive Power Supply Black Negative Power Supply Blue Normally Open (Electronic Lock) Purple Common Terminal Orange Normally Closed (Magnetic Lock) Yellow Exit Button Input Pink Doorbell Interface 3. Programming Basics

Fail-secure locks require electricity to unlock. They remain locked during a power outage. Connect Power Supply (+12V) to Keypad COM . Lock Connection: Connect Keypad NO to Lock (+).

Wiegand 26 bits input & output (can operate as an external reader) LED Indicator & Audio Reference Normal Mode: Red LED is lit. Programming Mode: Green LED is lit or flashing. Valid Action: Short beep sounds. Invalid Action: Long, sustained error beep sounds. 2. Wiring Diagram and Installation V2000-c Rfid Access Control User Manual

To modify user data or configuration settings, you must enter Programming Mode. Entering and Exiting Programming Mode

Connect to one side of a standard push-to-exit button (other side to GND) Connect to Doorbell unit terminal A Blue Connect to Doorbell unit terminal B Standard Installation Steps Before mounting, ensure the power is disconnected

Wrap any unused wires (like the doorbell wires if not used) with electrical tape to avoid accidental shorts. 3. Understanding the Status LED and Beeps

Before beginning the installation process, ensure your environment meets the technical requirements of the device. Technical Specifications 12V DC ± 10% Lock Connection: Connect Keypad NO to Lock (+)

Security isn't just about locks; it's about administration. The manual highlights how to change the default Master Programming Code.

Here are some common issues and FAQs related to the V2000-C RFID access control system:

All programming is done directly on the keypad. The default is usually 123456 (or sometimes 0000). 4.1 Entering Programming Mode

Press and hold down the # key (or the reset button located on the back PCB, depending on production batch). the device while continuing to hold the key. Release the key after hearing a series of short beeps.