Located on the right, these trigger programmed sequences or "chases."
Press the where you want to store the look. All LEDs on the controller will flash, confirming the scene is saved.
Press and hold the Program button for three seconds until the LED stops blinking. 4. Programming Chases disco 240 dmx controller manual
Because there are only 8 physical faders but 20 channels per fixture, the Page Select button switches between Page A (Channels 1–8), Page B (Channels 9–16), and Page C (Channels 17–20). Scene Buttons (1 to 8)
Press and hold button for 3 seconds to enter Program Mode (LED flashes). Located on the right, these trigger programmed sequences
Ensure the Blackout button LED is not flashing or turned on. When active, Blackout cuts all DMX output.
Select your desired sequence by pressing one of the buttons. Ensure the Blackout button LED is not flashing or turned on
Typically a 9V–12V DC input (minimum 500mA) via an external power supply.
If your moving heads are moving in the opposite direction of your fader pull, check your fixture's internal menu to see if you can invert the Pan or Tilt attributes locally.
The console changes scenes based on the sound detected by the internal microphone or line input. 6. Troubleshooting