In cooling mode, there is a compulsory delay ( Y ) before the compressor starts. This helps to extend its operational life by preventing rapid on/off cycles. However, for testing purposes, you can override this wait. Simply press the , and the delay will be canceled, allowing the compressor to start immediately.
The absolute maximum temperature allowed before corrective action is taken.
: Supports both refrigeration and heating modes with a double-limit (upper and lower) setting for opening and stopping equipment.
Relays connection to the compressor or heating element. 5. Maintenance & Safety xmk-010 manual
Refrigerator, freezer, and cold storage (e.g., LG display units) Control Logic Limit-based on/off control for compressors and fans Integration
Cut out a clean rectangular slot in your enclosure panel conforming to the 75x34mm chassis dimensions.
All certifications are referenced in with corresponding PDF copies available for download from the support portal. In cooling mode, there is a compulsory delay
XMK-010 Double-limit Digital Display Price Temperature Controller
Word leaked out in odd ways. A barista’s tablet started printing out the exact change for a forgotten tip. A municipal bench, when sat upon, played a recorded voice that recited a stranger’s childhood recipe. People began to whisper about a how-to that fixed more than machines. They did not speak of a manual by name. Names felt dangerous now. People who had never known the manual’s pages would report small, unlikely precisions: a bus that arrived exactly when needed, a lost photograph that found its owner.
| Terminal | Connection | Notes | | :--- | :--- | :--- | | | Connect to Neutral (N) Wire | Power input | | 2 | Connect to Live (L) Wire | Power input | | 2 & 4 | Link Terminals 2 & 4 | This links the relay's common | | 3 & 4 | Cooling Output | For cooling (e.g., connect to the contactor coil that drives a compressor) | | 4 & 5 | Heating Output | For heating applications | Simply press the , and the delay will
: Uses internal logic to trigger cooling or defrosting cycles based on user-defined thresholds. Safety Indicators
Press and hold the button for 3 to 5 seconds until the first parameter code (typically HC or F1 ) displays. Use the Δbold-italic cap delta or arrows to cycle through the available settings codes.
Connect your heating or cooling device through the relay output terminals.