If prompted for a password, leave it completely blank and hit Enter (some versions may use 888888 or 123456 , though FirstChip typically defaults to an empty password).
: Because mass production tools interact with low-level USB drivers and system kernels, antivirus programs often flag them as false positives.
Click on the "Setting" (设定) button. A password prompt may appear; if so, leave it blank and press OK.
The drive prompts a error. The device becomes permanently Write-Protected .
Limitations and known issues
A "Scan Fail" error (like "Scan Fail 3" or "Fail 8") typically means the tool cannot properly communicate with the NAND flash chip. This can often be resolved by:
If the fails to recognize your drive, you have two alternatives:
Before touching the software, you must understand the hardware. The FirstChip FC1178BC is a single-channel USB 3.0 controller. Unlike its predecessor (FC1178), the "BC" revision introduced native support for higher-density TLC (Triple-Level Cell) NAND and more aggressive wear-leveling algorithms.
Disclaimer: MPTools are designed for manufacturing. Using them on consumer drives voids the warranty. This guide is for educational and data recovery purposes only.
Before running MpTools, you must confirm that your USB drive actually contains the controller. Do not guess; flashing the wrong firmware can permanently kill the device. 1. Identify the Controller with ChipGenius
EagleEye Director II имеет встроенное обновляемое программное обеспечение. Обновление программного обеспечения происходит автоматически при подключении к кодеку, либо во время обновления ПО кодека. Также можно смостоятельно произвести обновление встроеного ПО.
РАБОТА ДОСТУПНА с версии 4.1 Если после восстановления заводских настроек система сбрасывается до версий ПО 4.0.0, 4.0.0.1 или 4.0.1, то сначала следует установить версию 4.0.2, после чего обновляться на более поздние версии.
Для получения других файлов обновлений (Download Firmware), а также всей технической документации посетите страницу продукта на портале support.hp.com
If prompted for a password, leave it completely blank and hit Enter (some versions may use 888888 or 123456 , though FirstChip typically defaults to an empty password).
: Because mass production tools interact with low-level USB drivers and system kernels, antivirus programs often flag them as false positives.
Click on the "Setting" (设定) button. A password prompt may appear; if so, leave it blank and press OK.
The drive prompts a error. The device becomes permanently Write-Protected .
Limitations and known issues
A "Scan Fail" error (like "Scan Fail 3" or "Fail 8") typically means the tool cannot properly communicate with the NAND flash chip. This can often be resolved by:
If the fails to recognize your drive, you have two alternatives:
Before touching the software, you must understand the hardware. The FirstChip FC1178BC is a single-channel USB 3.0 controller. Unlike its predecessor (FC1178), the "BC" revision introduced native support for higher-density TLC (Triple-Level Cell) NAND and more aggressive wear-leveling algorithms.
Disclaimer: MPTools are designed for manufacturing. Using them on consumer drives voids the warranty. This guide is for educational and data recovery purposes only.
Before running MpTools, you must confirm that your USB drive actually contains the controller. Do not guess; flashing the wrong firmware can permanently kill the device. 1. Identify the Controller with ChipGenius