Cisco+lab+162 Page

To complete Cisco Lab 162, participants follow a series of steps:

Use the following commands to verify your configuration works.

Better for advanced users needing to run real Cisco IOS images.

R1(config)# line con 0 R1(config-line)# password cisco R1(config-line)# login R1(config-line)# logging synchronous R1(config-line)# exit R1(config)# line vty 0 4 R1(config-line)# password cisco R1(config-line)# login R1(config-line)# transport input ssh R1(config-line)# exit Use code with caution. R1(config)# banner motd #Authorized Access Only# Use code with caution. Part 2: Interface Configuration (IPv4 and IPv6) Configure G0/0/0:

Implementing basic Access Control Lists to control traffic flow.

By mastering the steps in this lab, you are building the foundation required for advanced routing and switching topics, preparing yourself for the CCNA exam.

Configure Devices (IPv4/IPv6) and Verify Connectivity. Part 3: Configure Secure Remote Access (SSH).

transport input ssh : Explicitly blocks Telnet, dropping any unsecured administrative connections.

Upon completing Cisco Lab 162, participants gain hands-on experience in:

Router(config)# interface g0/0.10 Router(config-subif)# encapsulation dot1Q 10 Router(config-subif)# ip address 192.168.10.1 255.255.255.0 Router(config)# interface g0/0.20 Router(config-subif)# encapsulation dot1Q 20 Router(config-subif)# ip address 192.168.20.1 255.255.255.0 Use code with caution. Common Challenges and Troubleshooting

The core objective of Lab 162 is to isolate broadcast domains (VLANs) and then restore connectivity between them using Inter-VLAN routing without compromising security.

Router# show interfaces gigabitethernet 0/0

She checked the duplex. Full. Speed. 1000. All correct.